Electrolux EDC 5320 Instruction Booklet page 7

125992620 gb.qxd 18/02/2004
Pressing this button allows drying to be performed
at a lower temperature, for delicate items.
The corresponding pilot light comes on.
This option can also be used for time controlled drying.
This function cannot be used with "Quick drying"
7 "START/PAUSE"
Press this button to start the dryer after having
selected the programme and the options.
The relevant light will stop flashing.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again after
closing the door in order to restart the programme
from the point at which it was interrupted.
This button must be depressed also after a power
failure and after having re-inserted the water
reservoir, if it has been emptied in the middle of a
programme after lighting up of light
In both cases the light of the Start/Pause button
flashes to remind you that the start button needs to
be pressed again.
16:31 Pagina 7
button
.
8 Indicator lights
These lights indicate the following functions:
"Drying" light
.
This light indicates that the appliance is in the drying
phase.
"Cooling" light
This light indicates that the appliance is in the
cooling phase. At the end of drying, there is a
10 minute cooling phase to cool the laundry.
"End of programme" light
This light is on at the end of the cooling phase,
during the anti-creasing phase and at the end of the
programme.
"Filter cleaning" light
This light illuminates at the end of the programme to
remind you that the filters must be cleaned.
"Water reservoir full" light
This light comes on at the end of the programme to
remind you that the water reservoir must be emptied
out. If this light illuminates during a programme this
means that the water reservoir is full. The buzzer
sounds, the programme stops, the light of the
Start/Pause button flashes.
"Condenser cleaning" light
It comes on every 80 cycles to remind you that the
condenser must be cleaned.
7