Setting Up For Multiple Packs - BT HUDSON 1500 User Manual

2. Remove the protective film from the handset screen and activate
the batteries by pulling the plastic tab away from the back of
the handset.
3. Place the handset on the base to charge for at least 24
hours. When the handset is fully charged the
will be displayed.
4. After 24 hours, plug the telephone line cord into the
telephone wall socket.
Note: if you ever need to remove the batteries, simply slide open
the battery compartment cover and insert your finger nail under
the end of the batteries to pull them out.

Setting up for multiple packs

If you have purchased a BT Hudson 1500 multiple pack, you will
need to prepare any additional handsets and chargers for use.
For each additional handset and charger:
1. Insert the power adaptor with the red connector (item code
039955) into the underside of the charger. Plug the other end
into the mains wall power socket and switch on.
2. Remove the protective film from the handset screen and
activate the batteries by pulling the plastic tab away from the
back of the handset.
3. Charge the handset for at least 24 hours. When the handset is
fully charged the
Any additional handsets supplied as part of a multipack are
pre-registered to the base so, once charged, are ready for use.
The handset number is shown in the display.
If you experience any problems, please call the Helpline on Freephone 0808 100 6556* or visit www.bt.com/producthelp
icon will be displayed.
Battery low warning
The
display when you have only a
few minutes talk time remaining.
Recharge the handset before you
can use it again. You also hear a low
battery warning beep if the battery
is low and needs recharging. During
charging, the icon will scroll in the
display.
Battery performance
In ideal conditions, a fully charged
battery should give up to 10 hours
talk time or 100 hours standby time
on a single charge.
icon
Note that new batteries do not reach
full capacity until they have been in
normal use for several days.
To keep the battery in the best
condition, leave the handset off the
base for a few hours at a time.
Running the battery right down at
least once a week will help it last as
long as possible.
The charge capacity of rechargeable
batteries will reduce with time as they
wear out, giving the handset less talk/
standby time. Eventually they will
need to be replaced. New batteries
are available from the BT Hudson
1500 Helpline on 0808 100 6556*.
After charging your handset for the
first time, subsequent charging time
is about 6–8 hours a day. Batteries
and handset may become warm
during charging. This is normal.
Using your BT Hudson 1500 on a
Broadband line?
If this product is to be used on a
broadband line then you must
ensure that it is connected via an
ADSL microfilter. Using this product
on a Broadband line without an
ADSL microfilter may cause
problems with this product and
your Broadband service.
Additional BT ADSL microfilters can
be purchased from www.shop.bt.com
icon flashes in the handset
7