Additional Handsets And Bases; Register A New Handset To Base - BT FREELANCE XD5500 User Manual

Additional handsets and bases

46
Up to 5 handsets can be registered and operated from the BT
Freelance XD 5500 base.
Each handset can be registered with up to four bases.
If you buy new handsets to use with your BT Freelance XD
5500 they will have to be registered to the base before you
can use them.
Register a new BT Freelance XD 5500 handset to your BT
Freelance XD 5500 base
1. At the base: Press and hold
two beeps. You now have 90 seconds to register the handset.
2. At the handset: press
press .
3. Scroll to
4. Enter the base number (1–4). The numbers flashing are
already in use.
5. Press . When the handset finds the base signal, the base
identification number is displayed.
If the base is not found after a few seconds, the handset
returns to standby. Try registering again.
6. The display will ask for the PIN. Enter the PIN (default setting:
0000). You will hear a beep. The handset is now registered.
If you experience any problems, please call the Helpline on 0870 605 8047* or email bt.helpdesk@suncorptech.com
for 6 seconds until you hear
, scroll
and press
REG BASE
to and
REGISTER
.
Please note
Handsets that were supplied with your
BT Freelance XD 5500 base are already
registered to it as HS-1, HS-2 etc.
Each additional handset you buy MUST
be registered with the base.
IMPORTANT
Before registration, make sure the
handset batteries are fully charged and
that you are close to the base.