Recall; Dialling Mode - BT FREELANCE 101 User Manual

Switchboard external
line access code
You may need to enter an access
code (e.g. 9) in order to get an
outside line. So that the
switchboard has time to pick up
an outside line, you may also
need to add a Pause after the
access code.
A Pause lasts 3 seconds. You can
Pause dialling at any time by
pressing the P button.
To insert a pause
1. Begin storing a number and press
Pause
where a pause is needed.
Redial
shown in the display.
Please note
For more information on storing
numbers see 'Store a phonebook
number', on page 19.
Pause
You may also need to insert a pause
when storing international dialling
codes, charge card numbers and
with other tele-banking facilities.

Recall

The button is used when
R
Int
connected to certain
switchboards, e.g. to transfer
calls, and for some BT Calling
Features or those services
available via your network
provider.
Call the Helpline on 0870 605 8047 or email bt.helpdesk@suncorptech.com

Dialling mode

For instructions on how to
change the dialling mode, refer
to the section "To change the
phone settings" on page 25.
Temporary change to
dialling mode
If you have set your BT Freelance
101 to Pulse dialling, you can
temporarily switch to Tone
dialling during a call.
1. Press
dial the number as normal.
Your BT Freelance 101 will switch
is to Tone dialling only for the
P
duration of this call.
2. Press and hold
store the number in the
phonebook.
General information
, then press , then
before you
is displayed.
d
39