Related Manuals for GMC HD2G250M
Summary of Contents for GMC HD2G250M
- Page 1 1050W 2 GEAR HAMMER DRILL HD2G250M INSTRUCTION MANUAL Black Magenta Cyan Yellow Code: HD2G250M Date: 060323 Edition: 02 Op: DCR...
-
Page 2: Table Of Contents
Contents Warranty Description of symbols Specifications General safety rules Additional safety rules for drills Contents of carton Unpacking Know your product Auxiliary handle and depth gauge Inserting and removing bits Operation Variable speed trigger switch Speed adjustment Reversing the direction of rotation Drilling/hammer mode selector Gear selector Chuck replacement... -
Page 3: Description Of Symbols
Dear Customer If you require any help with your product, whether it � is a Warranty claim, spare part or user information, � please phone our Help Line for an immediate response. Phone 1300 880 001 in Australia or � 0800 445 721 in New Zealand. -
Page 4: General Safety Rules
General safety rules WARNING Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains operated (corded) power tool or battery operated (cordless) power tool. -
Page 5: Additional Safety Rules For Drills
Ensure that the lighting is adequate. • Do not put pressure on the drill, such that it slows the motor down. Allow the drill bit to cut without pressure. You will get better results and you will be taking better care of your tool. -
Page 6: Contents Of Carton
Auxiliary handle • Depth gauge • 250 Drill and bit accessories Unpacking Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. -
Page 7: Know Your Product
Know your product 1. Keyless rubber chuck 2. Auxiliary handle 3. Depth gauge 4. Drilling/hammer mode selector 5. Lock-on button 6. Forward/Reverse switch 7. Variable speed trigger switch 8. Speed dial 9. Spindle lock button 10. Gear selector... -
Page 8: Auxiliary Handle And Depth Gauge
Inserting and removing bits CAUTION. Always ensure that the drill is switched off and the plug is removed from the power point before making any adjustments. The drill is fitted with a... -
Page 9: Operation
Variable speed trigger switch 1. You can adjust the speed of the drill between zero and maximum by varying the pressure on the trigger. The harder you press on the trigger the faster the drill will operate. -
Page 10: Gear Selector
Turn the gear selector to Position “2”. NOTE. Do not change gears when the drill motor is turning. If you are having trouble changing gears, make sure that the gear selector is either completely in Position 1 or completely in Position 2 as you rotate the chuck by hand. -
Page 11: Hints For Use
If the job is too hard for the drill do not continue otherwise permanent damage to the motor will occur. -
Page 12: Cleaning
5. Wear eye protection when carrying out cleaning. CAUTION. Do not use cleaning agents to clean the plastic parts of the drill. Power cord maintenance If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an... - Page 16 Carefully read the entire Instruction Manual before using this product. Before returning this product for a Warranty Claim or any other reason Please Call 1300 880 001 (Australia) or 0800 445 721 (New Zealand) When you make your call, please have the following information at hand: GMC Product Type GMC Product Code A GMC Service Engineer will take your call and, in most cases, will be able to solve your problem over the phone.