Panel Connector; Irda Connector - AOpen MX64 User Manual

2.3.10 Panel Connector

The Panel (multifunction) connector is
a 20-pin connector marked as PANEL
on the board. Attach the power LED,
keylock, speaker, SPWR, IDE LED and
reset switch to the corresponding pins
as shown in the figure.
If your ATX housing supports ACPI
specification, the ACPI & Power LED
will keep flashing if you have enabled
"suspend mode" item in the BIOS
Setup.

2.3.11 IrDA Connector

The IrDA connector can be configured to support wireless infrared module,
with this module and application software such as Laplink or Win95 Direct
Cable Connection, the user can transfer files to or from laptops, notebooks,
PDA devices and printers. This connector supports HPSIR (115.2Kbps, 2
meters) and ASK-IR (56Kbps).
Hardware Installation
Caution: Locate the power switch cable from
your ATX housing. It is 2-pin female connector
from the housing front panel. Plug this
connector onto the soft-power switch connector
on the panel, which is marked as SPWR.
1 11
GND
KEYLOCK
+5V
IDE LED
IDE LED
+5V
+5V
GND
NC
SPEAKER
10 20
PANEL
1 11
+
Keylock
IDE LED
+
+
Speaker
10 20
PANEL
SPWR
GND
ACPI & POWER LED
GND
+5V
GND
GND
GND
RESET
GND
+
SPWR
+
ACPI &
Power LED
+
Reset
2-13