Holes Used For Mounting Boards And Wood Lathe To Leg Set; Mounting Left Side Table Top - RIDGID WL1200 Owner's Manual

Holes Used for Mounting Boards and Wood Lathe to Leg Set

G
H H
J
H
H
G
F
J
C
G
E
C
E
A - Board/Side Support
B - Board/Side Support
C - Plate Support/Board/End Support
D - Board/End Support
E - Headstock/Plate Support/Board

Mounting Left Side Table Top

1. Find the following:
1 Particle Board Table Top
1 Plate Support (Steel)
2. From the loose parts package find the following:
4 M6 x 1.0-45 Carriage Bolts
4 M6 x 1.0 Hex Head Nuts
4 6.5 x 19 x 1.6 Flat Washers
4 6mm Lockwashers
3. Position the table top on the left side of the assembled
legset as shown
4. Front Side Stiffeners
Face the front of the legset and count over from the left
one slot and one hole. Place a carriage bolt through
the table top (hole A) and the side stiffener. Fasten in
place with a washer, lockwasher and nut. Finger
tighten only.
5. Rear Side Stiffener
Face the rear of the legset and count over from the
right two holes. Place a carriage bolt through the table
top (hole A) and the side stiffener. Fasten in place with
a washer, lockwasher and nut. Finger tighten only.
6. Locate the two holes marked C in the steel plate sup-
port. Place bolts;
- through these holes
- through the two holes marked C on the table top
- and through the holes marked C in the End Stiffener.
Place a washer, lockwasher and nut on these bolts.
Finger tighten only.
B
A
B
A
F - Bracket Plate/Plate Support/Board/Side Support
G - Belt Gaurd/Plate Support
H - Motor/Plate Support
J - Cord Clamps/Plate Support
K - Rear Foot/Board
Particle Board Table Top
Flat Washer
6.5 x 19 x 1.6
9
D
D
Plate Support (Steel)
Carriage Bolt
M6 x 1.0-45
Lockwasher Nut Hex
6mm M6 x 1.0
K