Mounting Rear Foot - RIDGID WL1200 Owner's Manual

Assembly (continued)
6. Slide tailstock assembly onto the tube and install tail-
stock ram spindle lock lever. Be sure that the stud nut
engages the keyed way of the spindle.
7. On the backside of the tailstock, assemble the locking
devices as shown.

Mounting Rear Foot

1. Locate the following:
1 M8 x 1.25-45 Pan Head Screw
1 M8 x 1.25 Square Nut
1 M6 x 1.0-65 Carriage Bolt
1 6.5 x 19 x 1.6 Flat Washer
1 6mm Lockwasher
1 M6 x 1.0 Hex Nut
2. Install the rear foot onto the tube as shown and tighten
rear foot locking screw. Foot will wedge into plate as
screw is tightened. This may take several attempts.
3. Attach the rear foot on the right side table board, hole
labeled K. Secure in place with bolt, washer, lock-
washer and nut as shown.
Tailstock Ram
Spindle
Keyed Way
Headstock End
Tailstock Assembly
Carriage Bolt
M6 x 1.0-65
Pan Head Screw
M8 x 1.25-45
Flat Washer Lockwasher
6.5 x 19 x 1.6 6mm
Carriage Bolt
Headstock End
Tube Assembly
14
Lever
Assembly
Tailstock
Assembly
Lever
Assembly
Brass Shoe
Lock
Headstock End
Nut Square
Nut Hex
M8 x 1.25
M6 x 1.0
Pan Head Screw
M6 x 1.0-65
M8 x 1.25-45
Rear Foot
Square
Nut
Washer
Lockwasher
Nut
Hole K