Mounting Headstock - RIDGID WL1200 Owner's Manual

Mounting Headstock

1. Find the following:
1 Belt Guard Assembly
1 Headstock Assembly
1 Plate Bracket
2. From the loose parts package find the following:
2 M6 x 1.0-65 Carriage Bolts
1 M6 x 1.0-45 Carriage Bolt
1 M6 x 1.0-12 Hex Head Screw
4 M6 x 1.0 Hex Nuts
4 6.5 x 19 x 1.6 Flat Washers
4 6mm Lockwashers
4 M5 x 0.8-12 Pan Head Screws
4 5mm Lockwasher
3 M4 x 0.7-6 Screw
1 Hex "L" Wrench 4mm
3. Remove the headstock pulley using the 4mm hex "L"
wrench.
4. Find four pan head thread cutting screws and four
lockwashers from among the loose parts. Attach the
belt guard to the headstock assembly with these
screws and lockwashers. The arrows in this illustra-
tion show the location of the screws.
5. Locate the two holes on the left table top Labeled E
(from page 9). Position the headstock assembly so
the mounting holes line-up with the holes in the table
board. Place a M6 x 1.0-65 carriage bolt, through
these holes. Fasten in place with a washer, lock-
washer and nut.
6. Place the bracket plate next to the headstock as
shown. Attach the bracket plate to the back of the belt
guard assembly with a M6 x 1.0-12 screw, washer,
lockwasher and nut.
7. Locate Hole F on the left table board. Attach the
bracket plate to the table top through Hole F. Use an
M6 x 1.0-45 carriage bolt, washer, lockwasher and
nut. Finger tighten.
8. Locate the three holes Labeled G on the lower edge
of the belt guard plate. Place a M4 x 0.7-6 screw
through each of these holes and into the tapped
holes in the plate support.
9. Replace pulley on headstock tightening with 4mm
hex "L" wrench.
10. Securely tighten all nuts and bolts.
Belt Guard
Assembly
Carriage Bolt
M6 x 1.0-65
Carriage Bolt
M6 x 1.0-45
Nut Hex
Flat Washer
M6 x 1.0
6.5 x 19 x 1.6
Pan Head Screw
M5 x 0.8 x 12
Hex "L" Wrench 4mm
G
G
11
Headstock
Assembly
Hex Head Screw
M6 x 1.0-12
Lockwasher
6mm
Pan Screw
M4 x 0.7-6 Lockwasher
5mm
G
M6 x 1.0-12
Hex Head Screw
M6 x 1.0-45
Carriage Bolt
Bracket
Plate