Displaying Tmc Messages On The Map; Using Tmc - Becker TRAFFIC ASSIST HIGHSPEED Operating Instructions Manual

Navigational mode
Note:
As the traffic announcements are trans-
mitted by radio stations, we cannot as-
sume responsibility for the complete-
ness or accuracy of the announcements.
Austria: The location and event code
was made available by ASFINAG and
BMVIT.
If dynamic route guidance is active, a
continuous check is made for the
presence of relevant announcements for
the selected route (however, traffic
problems still appear on the map even
when route guidance is not active).
6071
If these continuous checks determine
that a traffic announcement is relevant to
route guidance, the
automatically recalculate a new route to
the destination (See "The TMC button*"
on page 54.).
57
Displaying TMC messages on
the map*
Current TMC messages are displayed on
the map in graphic form. Sections of the
route where there are problems with
traffic are highlighted green. A black
arrow also indicates the direction of the
traffic jam.
In addition to the coloured mark, a
warning sign is displayed on the stretch
of road affected.
6071
unit will
*Applies only to the Traffic Assist Highspeed II

Using TMC*

Once you have connected the TMC
antenna, your Traffic Assist Highspeed
will receive current
announcements and dynamic route
calculation will be enabled (traffic jam
diversion). You can also view traffic
announcements directly.
To preset the TMC, See "The TMC
button*" on page 54.
! Press the map on the map display.
6071
Press the TMC button.
!
All current traffic announcements are
displayed.
traffic