Minolta Di152 User Manual page 130

8
Error Display
8-2
Error Displays and Other Indicators
Possible Cause
A sheet of misfed paper is left in
the copier.
A sheet of paper is left on the
Manual Bypass Tray.
Copier cover is left open or not
closed in position.
The Automatic Document
Feeder is in a raised position.
The Document Feeder Cover
(Doc. Feed Cover) of the
Automatic Document Feeder is
open.
Memory is full when the image
data is read.
Memory is full when image data
is received from the personal
computer.
A size error has occurred with
the paper loaded in the tray.
The Plug-In Counter is not
plugged in.
The numerical value entered
falls outside the setting range.
The scheduled maintenance
time has arrived.
Action
Identify the misfeed location on
the control panel and remove the
sheet of misfed paper. "Clearing a
Paper Misfeed" (p.8-12)
Remove the paper from the
Manual Bypass Tray.
Identify the closure failure location
on the control panel and close the
cover in position.
Properly lower the Automatic
Document Feeder into position.
Close the Document Feeder
Cover (Doc. Feed Cover) in
position.
Press the [Panel Reset] key. Or,
turn OFF, then ON, the Power
Switch. (This will erase all data
that has so far been read.)
Press the [Panel Reset] key. Or,
turn OFF, then ON, the Power
Switch. (This will erase all image
data that has so far been
received.)
Press the [Clear] key, slide out the
tray in which the size error has
occurred, and slide it back into the
copier.
Check the paper size set with
Custom Size Input and carry out
the Custom Size Input procedure
once again.
Plug in the Plug-In Counter.
Check the value and enter the
correct one as necessary.
Call your Tech. Rep.
Di152/Di183