Left Side Panel Features; Installing Memory Cards - Honeywell Dolphin 6100 User Manual

Left Side Panel Features

Side Button
There is a button like this on both side panels. You can use the Programs Buttons option in
the Control Panel to change the functionality of the scan buttons.
Side Door
The rubber door on the left side panel provides access to the Micro SD slot.
When closed, the side door seals the terminal from moisture and particle intrusion thus
preserving the terminal's environmental rating.

Installing Memory Cards

The 6100 supports Micro Secure Digital (SD) memory cards of the following capacities:
• 2 GB
• 4 GB
To install an SD card
1. Press Power key to put the terminal in suspend mode; see
2. Open the access door on the left side.
3. Insert the SD card with the label facing upward.
Note: To remove an installed SD card while the access door is open, tap on the edge lightly to unlock
the card; the card will pop out just enough for you to grab its edge and pull it out.
4. Replace the access door.
The rubber door is required for 1) proper functioning of the SD card and 2) preserving the
environmental rating for water sealing. Do not remove the rubber door.
Note: Do not use the terminal when the access door is open. When this door is fastened securely and properly, the
memory interface is sealed against moisture and particle intrusion, read/write data is stored securely, and the
terminal's environmental rating is preserved.
5. Tap the Power key to resume operation.
6. To verify that the operating system recognizes the new memory card, open Windows Explorer and
navigate to My Device\Storage Card.
Micro SD Slot
Side Button
Suspend Mode on page 3-16.
3 - 9