Sidestand - Yamaha Wild Star XV1600A Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
3. Tighten the locknut to the speci-
fied torque.
Tightening torque:
Locknut:
35 Nm (3.5 m·kg)
3
CAUTION:
@
Always tighten the locknut against
the spring adjusting nut and tighten
the locknut to the specified torque.
@
WARNING
@
This shock absorber contains high-
ly pressurized nitrogen gas. Read
and understand the following infor-
mation before handling the shock
absorber. The manufacturer cannot
EC000018
be held responsible for property
damage or personal injury that may
result from improper handling.
Do not tamper with or attempt to
open the cylinder assembly.
Do not subject the shock ab-
sorber to an open flame or other
high heat source. This may
cause the unit to explode due to
excessive gas pressure.
Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
damping performance.
Take your shock absorber to a
Yamaha dealer for any service.
@
3-15
EAU00315

Sidestand

This model is equipped with an ignition
circuit cut-off system. The motorcycle
must not be ridden when the sidestand
is down. The sidestand is located on
the left side of the frame. (Refer to
page 5-1 for an explanation of this sys-
tem.)
WARNING
@
This motorcycle must not be operat-
ed with the sidestand in the down
position. If the stand is not properly
retracted, it could contact the
ground and distract the operator, re-
sulting in a possible loss of control.
Yamaha has designed into this
motorcycle a lockout system to as-
sist the operator in fulfilling the re-
sponsibility of
sidestand. Please check carefully
the operating instructions listed be-
low and if there is any indication of a
malfunction, return the motorcycle
to a Yamaha dealer immediately for
repair.
@
EAU00330
EW000044
retracting the