Yamaha TW200 Owner's Manual page 40

3
4 2
1. Drain plug
2. O-ring
3. Compression spring
4. Oil strainer
cC
When removing the oil drain plug,
the O-ring, compression spring,
and oil strainer will fall out. Take
care not to lose these parts.
NOTE:
The oil filter cover is secured by
two screws and a drain bolt.
Remove the drain bolt to drain the
filter cavity.
PERIODIC MAINTENANCE AND MINOR REPAIR
1
1
1. Filter cover screw (×2)
2. Drain bolt
d. Remove the filter cover screws
and the oil filter cover.
EC000070
e. Remove the oil filter element
and O-ring.
f. Clean the oil filter and strainer
with solvent. Replace if neces-
sary.
g. Check the O-rings. If damaged,
replace.
h. Install the drain plug, filter
cover, screws and drain bolt.
Tighten the drain plug to the
specified tightening torque.
2
1. Oil filter
2. O-ring (×2)
NOTE:
Make sure the O-ring is seated
properly.
cC
Before reinstalling the oil drain
plug, do not forget to install the O-
ring, compression spring, and oil
strainer in position.
6-10
1
2
EC000071
1
2
3
4
5
6
7
8
9