Activating The Child Safety Device - AEG FM 7531K-an Instruction Book

Mounting
The unit may be mounted in any
type of kitchen worktop with a
thickness of 28 to 40 mm.
Cutting Out
When mounting the hob: Read the
instructions on this page. When
mounting this unit together with
other units: Read the instructions on
the next page.
For mounting this hob you need a
Philips screwdriver and the 4 clamp-
ing fittings supplied with this prod-
uct (see fig.).
Distance to Wall:
Minimum 150 mm to flammable
material. Minimum 50 mm to non-
flamable material.
1. Cut a hole in the table top
according to the measures stated.
See "Technical data", "built-in
measurement".
2. Place the unit upside down on a
mat. Take care that the top side is
not scratched.
3. Mount the clamping fittings in
the holes in the side of the base
panel (see fig.)
4. Place the unit in the hole and
tighten the clamping fittings to
the table top using a screwdriver.
Clamping fittings
Mounted clamping fittings
26
Activating the Child Safety
Device
With the child safety function chil-
dren can be prevented from turning
on the hob unintentionally.
When the child safety is activated
k
you can still use the key and the
minute minder.

Activating the Child Safety Device

k
1. Turn on the hob, push the
key
j
2. Push the key for 3 seconds.
The control lamp for child safety
lights up.
If you try to turn on the hob when
the child safety is activated the con-
k j
trol lamps for and will light
up.
k
Push again on to turn off.
To use the hob when the child safety
is activated do the following:
k
1. Push the key.
j
2. Push the key and the key you
wish to use simultaneously.
The child safety is disengaged while
the hob is in use. When the hob is
turned off the child safety is auto-
matically activated.
15