Residual Heat Indicator; Automax - AEG FM 7531K-an Instruction Book

Residual Heat Indicator

Each cooking zone has a residual
heat indicator. When the cooking
zone is turned off the "H" is lit up in
the display until the cooking zone
has cooled. "H" is a warning that the
cooking zone is still hot.

Automax

With AUTOMAX you do not need
to turn down the temperature. When
using AUTOMAX the zone gets full
heat for a certain amount of time
where after the cooking zone auto-
matically adjusts to the setting you
have chosen.
To adjust AUTOMAX you have to
do the following:
k
1. Turn on the hob, push .
2. Adjust the desired cooking zone
at the setting you wish to use.
N
3. Push .
When AUTOMAX is coded the con-
trol lamp for "A" will light up.
To turn off AUTOMAX, you have to
N
push .
The "AUTOMAX" chart on the fol-
lowing page gives guidelines for
suitable heat settings for different
types of cooking.
12
To optimise joints between the installed hobs, the gap between the ceramic hob
may be grouted with silicone:
1. Remove the aluminium panels from the hobs.
2. Apply a stripe of silicone to the gap between the two ceramic hob. Use only
the silicone supplied, as it is designed to tolerate the appliance's high temper-
ature. (Fig. 1)
3. Splash a little soapy water (washing-up liquid) on the silicone stripe
4. Press the rubber block hard against the ceramic hob and pull it slowly from
back to front (Fig. 2)
5. Leave the silicone to harden until the next day.
6. Remove surplus silicone coating from the ceramic hob with the razorblade
supplied. Be careful not to damage the silicone in the gap. Run tools only
along the joint, never across it.
7. Polish the ceramic hob with the supplied cleaning product for ceramic hobs.
1
2
29