What To Do If - AEG B8871-4 User Manual

56

What to do if ...

What to do if ...
The oven does not heat up The oven is not switched on
The oven lighting is not
operating
Pyroluxe is not working
("C1" appears in the clock
display)
The oven does not heat up.
Time
F11 appears in the clock
display
F2 appears in the clock dis
play
In the clock display there
appears a fault code that is
not listed above
Problem
The clock is not set
The required settings have not
been set
The oven's safety cut out has
been tripped
The fuse in the house's electri
cal wiring (fuse box) has been
tripped
The oven bulb is faulty
Side rails/oven shelf runners
have not been removed
Demo mode is on
is lit
The meat probe has short
circuited or the plug of the
meat probe is not firmly in po
sition in the socket
Door not properly closed or
door lock defective
Fault in the electronics
Possible cause Remedy
Switch the oven on
Set the current time on the
clock
Check the settings
See "Safety fuse"
Check fuse. If the fuses trip re
peatedly, please call an author
ised electrician
Change the oven bulb
Remove side rails/oven shelf
runners
Keep Select button
pressed for 2 seconds, then
within 2 seconds press and
hold buttons Select
for 2 seconds
Insert the plug of the meat
probe as far as it will go into
the socket on the side wall of
the oven
Close door properly;
Turn the appliance off and on
again via the house fuse or the
safety switch in the fuse box;
If displayed again, please con
tact the Customer Care De
partment
Switch off the appliance via
the house fuse or the safety
switch in the fuse box and
switch it on again.
If displayed again, please con
tact your local Service Force
Centre
and