Table of Contents
Advertisement
Recording a TV Program
Preparation
Turn on the TV, and select the AV-program position on TV.
1
Load a blank cassette tape with the erase prevention
tab intact. (The VCR will
automatically turn on.)
VCR
2
Select the program you want to record with CH
or 10 number buttons.
1~9:
e.g. 5 = press "5"
10~80:
e.g. 29 = press "2" and "9".
3
If a recording in Long Play mode is intended,
press SPEED SP/LP to display "LP". To check
the tape speed, press CALL (see bottom right on
this page).
4
Press REC/OTR to start
recording.
If the erase prevention tab is removed, the tape
will eject when REC/OTR is pressed for recording.
To Stop Recording
Press
.
To Stop Recording Temporarily
To stop a recording for a
short period of time press
PAUSE/STILL. Press
this button again if you
want to resume the
recording.
Attention:
A safety circuit turns the pause mode off
automatically after 5 minutes, and the VCR will
stop the recording mode.
Note:
Since the VCR has a built-in TV tuner the TV set
may be turned off when recording. The TV set may
only be used to check for accurate program
adjustments or to monitor recordings.
18
CH 29
NICAM ST
RTL
VCR
INDEX
VCR
VCR
Recording with a SCART Cable
You can record a program using the TV receiver
of the VCR and at the same time watch another
program on the TV set using its receiver. As the
VCR automatically switches the TV set the
following points should be observed:
1
Press TV/VCR until "VCR" appears on the
display. Select the program on the VCR you want
to record. This program can
be watched on the screen
and recorded by the VCR.
2
While the VCR is recording press TV/VCR until
VCR
the "VCR" indicator on the display goes off. The
TV set now displays the program of its built-in
receiving module. Select the TV channel you
want to watch on the TV set. Although the TV set
now shows another program the VCR will
continue recording the
previously
program.
3
Using TV/VCR you can switch the TV screen
between the VCR picture and the TV picture. If
the "VCR" indicator is lit on
the display, you will watch
the VCR picture. This has no
trouble on the recording.
Auto Rewind Feature
The VCR will automatically rewind when the tape
has ended (except during OTR and TIMER REC).
It will also eject the cassette tape and turn the
unit's power off.
To Display VCR operation Status
Press CALL. The clock, day of the week and more
informations will be indicated.
To cancel the indicating: Press CALL until all
indicator disappear.
Day of the week
Time
23:59 SUN
Cassette
in Unit
Stand of Tape
counter
selected
Deck-status
here: Playback
Program
CH 80
number or
****
Scart input
(AU)
*Station's
01:36:58 SP
name (e.g.
NRK)
Tape speed
VCR
VCR
Advertisement
Table of Contents
