Table of Contents
Advertisement
Loading and Unloading a Cassette Tape / Playback
Loading and Unloading a Cassette Tape
Use only video cassette tapes marked
. Loading
Push the center of the tape until it is automatically
inserted.
Insert the cassette tape with its labeled side facing
up and the erase prevention tab positioned at your
left. An inverted cassette tape cannot be inserted.
Erase prevention tab
Automatic power ON
When you insert a cassette tape the VCR power will
turn ON automatically.
Automatic playback
When loading a cassette tape without an erase
prevention tab, playback will start automatically.
Unloading
1
Press STOP/EJECT on the VCR. When a tape
is being played press this button twice.
:
OR
Press EJECT on the remote
control. Even if a tape is
being played, press this
button only once.
2
Remove the cassette tape.
Automatic tape eject
When the VCR is automatically rewinding the tape
and reaches its beginning, the cassette tape will be
ejected automatically.
To prevent accidental erasure
Remove the erase prevention tab with a screwdriver.
inspelningsskydd
To record again
Cover the hole with a piece of adhesive tape.
14
VCR
VCR
VCR
Screwdriver
Adhesive
tape
Playback
Preparation
Turn on the TV, and select the AV-program position
on TV.
1
Load a pre-recorded cassette tape. When loading
a cassette tape without an erase
prevention tab, playback will start
automatically.
2
Press
. Playback will start.
If the cassette has not
loaded yet,
will blink
for 4 seconds.
To stop playback
Press
.
To rewind the tape or forward it rapidly
To rewind the tape:
Press
.
VCR
Forward/reverse picture search mode
When the tape is being transported you can switch to
picture search mode (see next page). To do this,
press
or
resume the tape transport as soon as the button is
released.
NTSC Video cassette-Playback
When using a pre-recorded NTSC video cassette
tape, the connected TV set must operate with a 60
Hz vertical frequency. Otherwise the on-screen
picture will be affected by vertical rolling. Even if your
TV set is capable of processing NTSC video signals,
the picture may be shortened vertically (appearance
of black bars at the top and at the bottom of the TV
screen). The dubbing of a NTSC video cassette tape
to a standard PAL VCR is not possible.
VCR
VCR
ATR
VCR
To forward the tape:
Press
.
VCR
and hold it down. The unit will
Advertisement
Table of Contents
