Remote Control - Akai QX-3700 Operator's Manual

Remote control

1
2
5
4
8
9
12
13
15
17
Preparation of remote control
1. Remove the cover of the battery compartment on the rear of
the remote control.
2. Insert two AA batteries with correct polarity (+/-) marking
indicated inside.
3. Close the cover.
Remove the batteries when not using the unit for a long time.
When replacing the batteries, replace them both at the same
time, don not mix the old and new batteries.
1. : to turn on from standby
2. MUTE: to turn the sound on or off
(OPEN/CLOSE): to open/close the disc tray
PREVIEW: to scan through the track on the disc
OSD: to display the playing information
RESUME: to resume playing from the stopping point
DISPLAY: to display the screen chart
3. Number buttons (1-9, 10/0, 10+): to select track
4. CLOCK: to set the clock
3
5. ENTER: to confirm the set
6. SET: to set the clock digit
7. - VOLUME +: to decrease or increase the volume
8. FUNCTION: function selection
DOWN/UP: to select the function set downward or upward
6
9. PBC: menu playback control
7
10. KEY CONTROL (TONE) buttons
: to lower the tone
10 : to resume the tone
: to raise the tone
11 11. Basic operation buttons
: to stop play
14
: to play or pause
16
12. GO TO: to go to the selected playing time
13. REPEAT: to repeat play
18
14. SLOW: to play in slow motion
19
15. SURR: to select the sound effect
20
16. MEM: to preset memory
PROG: to program playback
17. L/R: to select the Left, Right or Stereo channel
ST/MONO: to switch stereo and mono sound
18. BAND: to select AM/FM band
PAL/NTSC: to select the PAL or NTSC system
19. : to search reverse or forward
- TUNING + : to auto or manual tuning
20. : to skip reverse or forward
- CHANNEL + : to select the preset number
Usage of remote control
Point the remote control at the sensor on the unit and then press the
button.
The remote control operates within a range of 30
right of the system and 8m or less from it.
QX-3700
Do not expose remote control to high temperature or high
humidity.
Avoid exposing the remote sensor window to direct sunlight or
strong light.
When operating the remote control, make sure that it is pointed at
the remote sensor window on the unit.
- 6 -
within 8m
to the left or
o