Using Your Removable Handheld Steamer With Direct Steam Nozzle - Shark S3901UKL Owner's Manual

Using Your Removable Handheld Steamer
with Direct Steam Nozzle
Cleaning Tip: The Direct Steam Nozzle creates direct steam spray to clean and sanitise
hard to reach nooks & crannies and other places where germs may build up. Use the
Direct Steam Nozzle to loosen and dislodge compact dirt often found in corner and tight
places where traditional methods and cleaning tools tend to push dirt into, making it
tough to reach and clean. Spray direct steam and wipe clean with a wet cloth or paper
towel.
fig. 16
FOR SPOT CLEANING AND STEAMING
2 Remove the Direct Stream Nozzle from the
storage clip on the mop handle and attach it by
pressing the nozzle onto the Handheld Steamer
until it clicks into place. (fig. 16, fig. 17)
3 The Handheld Steamer is automatically set to
SCRUB mode. Squeeze the steam trigger to
activate steam. To change modes press the ON/
STEAM SETTING button to select either DUST,
MOP or SCRUB mode. You can change the steam
mode while the Handheld Steamer is in standby
or in use. Once the selected setting indicator
light has turned blue, hold down the steam
trigger to start steaming. (fig. 18)
For effective cleaning, hold the steam output
nozzle 1-2 inches away from the surface you're
cleaning.
fig. 17
4
fig. 18
CAUTION: Do not press the steam trigger until
the Direct Steam Nozzle is snapped into the main
nozzle of your Handheld Steamer.
To remove the Direct Steam Nozzle, press and
hold down the Handheld Release Buttons. Then
slide out the Direct Steam Nozzle using the grip.
CAUTION: Do not press the steam trigger
while removing the Direct Steam Nozzle. Avoid
touching the tip of the Direct Steam Nozzle, as
this will be very hot after steaming.
NOTE: The Handheld Steamer may continue to
emit steam for a few seconds after the trigger is
released. This is normal, and the steaming will
eventually come to a stop.
www.lakeland.co.uk 11