Dispensing Hot Water - Baumatic BEC2.1SS Instruction Manual

o You should not touch any other button on the coffee machine
until the water reservoir has finished filling.
o IMPORTANT: Leave the water softener immersed in water for 5
minutes before attempting to make a drink. You only need to do
this the before using the machine for the first time or if you have
changed the water filter.

Dispensing hot water

o Fill the water reservoir if your appliance is not connected to your
mains water supply.
o Switch the machine on using the ON/OFF switch (12).
o Let the water reservoir fill with water automatically if it is
connected to your mains water supply.
o The green water boiler neon (25) will start to flash, to indicate
that the coffee boiler is heating up.
o The machine is ready to dispense water when the water boiler
neon (25) stops flashing and remains lit.
o Place a cup underneath the filter holder ring nut (5) and then
press the water boiler ON/OFF button.
It is possible to dispense water in two different ways:-
Manual dispensing- Press the water boiler ON/OFF button (29) for
less than one second. After a few seconds the machine will start to
dispense water. You should press the water boiler ON/OFF button
again to stop it dispensing.
Automatic fixed time dispensing- Press and hold down the water
boiler ON/OFF button (29) for longer than one second but less than
four seconds. The machine will dispense water for a fixed length of
time that you have programmed previously.
It is perfectly normal for there to be a noise and a small
amount of water backfilling into the drip tray, after water
has been dispensed.
13