Table of Contents
Advertisement
Introduction to Your System
This system offers you three forms of protection: burglary, fire and emergency.
Monitoring is accomplished with various contact and motion sensors for perimeter
and interior burglary protection, plus strategically placed smoke, heat, or
combustion detectors.
Burglary Protection
The burglary protection portion of your system must be turned on or "armed" before
it will sense burglary alarm conditions. Your system provides three modes of
burglary protection: Away, Stay, and Night, and even allows you to "bypass"
selected zones of protection while leaving the rest of the system armed (e.g. this
enables you to arm the system but leave upper-story windows open.)
The system also provides a Chime mode, for alerting users to the opening and
closing of doors and windows even while the system is disarmed.
Partitions
This system provides the ability to arm and disarm up to eight different areas, each
as if it had its own control. These areas are called partitions. Partitions are used
when the user wants to disarm certain areas while leaving other areas armed, or to
limit access to certain areas to specific individuals. Each user of the system can be
authorized to operate all or only some partitions, and can be given different
privileges in each. Information about Partitions is presented later in this document.
Zones
Your system's sensing devices have been assigned to various "zones." For example,
the sensing device on your Entry/Exit door may have been assigned to zone 001,
sensing devices on windows in the master bedroom to zone 002, and so on. These
numbers will appear on the display, along with a Custom English descriptor for that
zone (if programmed), when an alarm or trouble condition occurs.
Entry/Exit Delays
Your system has preset time delays, referred to as exit delay and entry delay.
Whenever you arm your system, exit delay gives you time to leave through the
designated exit door without setting off an alarm. Exit delay begins immediately
after entering any arming command, and applies to all modes of arming protection.
If programmed, a slow beeping will sound throughout the exit delay period.
Entry delay gives you time to disarm the system when you reenter through the
designated entrance door. But the system must be disarmed before the entry delay
period ends, or an alarm will occur. The touchpad will beep during the entry delay
period, reminding you to disarm the system. Ask your installer about the delay
times programmed into your system.
System Overview
13
Advertisement
Table of Contents
