2-Track In/Out; Rear Panel; Power; Phantom - Alto L-8 User Manual

- 2-TRACK IN/OUT

Input
Use the Tape input if you wish to listen to your Mix from a Taper Recorder or DAT, you can assign the signal coming
form the Taper Recorder either to a pair of studio monitor using the Control Room assignment on the front panel or
directly to the Main Mix.
Output
These 1/4" TRS sockets will route the main mix into a tape recorder.
4.12 REAR PANEL DESCRIPTION

POWER

ON
OFF
- POWER
This switch is used to turn the Main Power ON and OFF.

- PHANTOM

This switch will apply +48 Volt Phantom Power only to the 5 XLR microphone inputs. Never connect microphones
when the Phantom Power is on already.

- AC INLET WITH FUSE HOLDER

Use it to connect your L-8 to the Main AC with the supplied AC cord. Please check the Voltage available in your
Country and make sure the Voltage for your L-8 before attempting to connect your L-8 to the Main AC.

- MAIN MIX OUTPUT

This stereo output is supplied both with XLR and 1/4" jack socket and it is controlled by the Main Mix Level on
the front panel. It will send the audio signal to an amplifier. The output level can be varied from -

- CONTROL ROOM OUTPUT

These 1/4" phone sockets will be used to send the signal to Studio Monitor speakers or to a second set of PA.
30
31 4
PHANTOM
fuse fuse fuse 250V 250V 250V a a a with with with only only only Use Use Use
AC INPUT
EUROPE
210-240V
Fuse:T250mAL
RATED POWER CONSUMPTION: 25W
32
USA / Canada
100-120V 60Hz
Fuse:T500mAL
31
4
33
34
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
MAIN MIX OUTPUT
(BAL/UNBAL)
RIGHT
2 1
3
50Hz
33
UK / Aust
240V 50Hz
Fuse:T250mAL
32
13
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: SHOCK HAZARD
- DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE
CONTROL
ROOM OUTPUT
LEFT
2 1 LEFT
3
RIGHT
- NE PAS OUVRIR
LEFT
RIGHT
34
to +15dB.