ZMODO IP Camera User Manual page 19

[DNS address] If the user has a DDNS account, the DNS address needs to be set
to the DNS address of the place to which the device is assigned to in the DNS
account.
[Hotspot Search Results] After enabling Wi-Fi, the camera will automatically
search for wireless networks in the area. When the camera is searching for a
wireless network you will see the following information listed: the name of the
wireless router, signal intensity, and the encryption type. Click on "add hotspot"
or double-click on an existing hotspot to open the "Wi-Fi Hotspot Setting" dialog
box as the figure below shows:
If this screen was entered by double-clicking an existing hotspot, the hotspot will
be assigned automatically.
If this screen was entered by clicking "Add hotspot," then type in the SSID,
corresponding encryption mode, and the network password.
Click [Establish Connection] to establish a connection with the wireless
network. You will be presented with a success or a failure message with the
result of this connection.
If connected, "Connected" will appear after hotspot name; if not, please click
"Refresh" to refresh connection status or click this button to search device again.
Figure 4-7 Wi-Fi Hotspot setting
17
®