Oil Change Required - If Equipped - Chrysler 200 CONVERTIBLE 2011 Owner's Manual

• Remote start aborted — Fuel low
• Remote start disabled — System fault
• Convertible Top Not Secured (with a single chime)
• Convertible Top Complete (with a single chime)
• Secure Cargo Shield (with a single chime)
• Speed Too High (with a single chime)
• Convertible Top Malfunction (with a single chime)
• Oil Change Required (with a single chime)
• ECO (Fuel Saver Indicator) — If Equipped
• Low Pressure (with a single chime) Refer to Tire
Pressure Monitoring System in Starting and Operat-
ing .
• Check TPM System (with a single chime) Refer to Tire
Pressure Monitoring System in Starting and Operating .
UNDERSTANDING YOUR INSTRUMENT PANEL 213
Oil Change Required — If Equipped
Your vehicle is equipped with an engine oil change
indicator system. The "Oil Change Required" message
will flash in the EVIC display for approximately five
seconds after a single chime has sounded to indicate the
next scheduled oil change interval. The engine oil change
indicator system is duty cycle based, which means the
engine oil change interval may fluctuate dependent upon
your personal driving style.
Unless reset, this message will continue to display each
time you turn the ignition switch to the ON/RUN
position. To turn off the message temporarily, press and
release the Menu button. To reset the oil change indicator
system (after performing the scheduled maintenance),
perform the following procedure:
1. Turn the ignition switch to the ON position (Do not
start the engine.)
4