Gate Operator/Canadian Programming; Using Homelink - Chrysler 200 CONVERTIBLE 2011 Owner's Manual

176 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Gate Operator/Canadian Programming

Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this
Canadian law, some U.S. gate operators are designed to
time-out in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace "Programming
HomeLink " Step 3, with the following:
3. Continue to press and hold the HomeLink button,
while you press and release ("cycle"), your handheld
transmitter every two seconds until HomeLink has
successfully accepted the frequency signal. The indica-
tor light will flash slowly and then rapidly when fully
trained.
If you unplugged the device for training, plug it back in
at this time.
Then proceed with Step 4 under "Programming
HomeLink ," earlier in this section.

Using HomeLink

To operate, press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e., garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.,). The handheld transmitter of the device may also be
used at any time.