After Starting; Engine Block Heater - If Equipped; Automatic Transmission - Chrysler 200 CONVERTIBLE 2011 Owner's Manual

CAUTION!
To prevent damage to the starter, wait 10 to 15 sec-
onds before trying again.

After Starting

The idle speed will automatically decrease as the engine
warms up.
ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded, three-wire extension cord.
The engine block heater cord is bundled under the hood
between the headlight assembly and the Totally Inte-
grated Power Module (Fuse Box) on the driver's side of
the vehicle.
The engine block heater must be plugged in at least one
hour to have an adequate warning effect on the engine.
WARNING!
Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt
electrical cord could cause electrocution.

AUTOMATIC TRANSMISSION

CAUTION!
Damage to the transmission may occur if the follow-
ing precautions are not observed:
• Shift the shift lever into PARK only after the
vehicle has come to a complete stop.
STARTING AND OPERATING 297
(Continued)
5