Installation
◆ Precautions when laying power wiring
Use round pressure terminals for connections to the power terminal block.
When none are available, follow the instructions below.
• Do not connect wiring of different thicknesses to the power terminal block. (Slack in the power
wiring may cause abnormal heat.)
• When connecting wiring which is the same thickness, do as shown in the figure below.
• For wiring, use the designated power wire and connect firmly, then secure to prevent outside pressure
being exerted on the terminal block.
• Use an appropriate screwdriver for tightening the terinal screws. A screwdriver with a small head will
strip the head and make proper tighterning impossible.
• Over-tightening the terminal screws may break them.
Conduit connection
1. Set the connecting cable into the terminal
block of indoor unit, and tighten set screw to
lock the conduit bracket to the indoor unit.
2. Join the conduit and the conduit bracket
together.
3. After connecting the remote controller wire ,
complete to use conduit
CAUTION: Must use the
elbow type (L-Type)
conduit.
Lock nut
Conduit
bracket
Conduit
14 Ventilator
Round pressure terminal
Power wire
Remote
controller
hole
Cord Clamp
Lock nut
Conduit
bracket
Conduit
Lock nut
Conduit
bracket
Conduit
Remote
controller hole