Table of Contents
Advertisement
Mid-Static Ducted Vertical Installation Conversion Kit Wiring
DANGER
When installing / replacing / servicing, wear anti-static gloves to prevent static electricity. Fire and electrical shock can cause physical injury or death.
If the vertical installation conversion kit has been installed on the
mid-static ducted indoor unit, additional electrical work is required.
See the previous page.
Step 1.
Open the control box cover. Disconnect the wires on CN_D_PUMP
and CN_FLOAT on the mid-static ducted indoor unit PCB.
Step 2.
Connect terminals for CN_D_PUMP (white) and CN_FLOAT (blue)
(factory-provided accessories included with the conversion kit) as
shown in the image at right.
Step 3.
Coil up and tie any extra wiring and close control box cover.
DANGER
When installing / replacing / servicing, wear anti-static gloves to prevent
static electricity. Fire and electrical shock can cause physical injury or
death.
Using a Conduit for Indoor Unit Wiring /
Cable Installation
(power) cable.
1. Assemble the conduit with a grommet and washer (field-supplied separately or included with the
elbow connector).
2. Guide the power wiring / communication cable into the conduit assembly..
3. Attach the conduit assembly to the indoor unit with a lock nut.
Check local, state, and federal codes when choosing a conduit size.
4. To protect the piping, condensate drain, and conduit from the elements, add a lineset cover from the
indoor access hole to the outdoor unit.
drain, power wiring / communication cable bundling information.
ELECTRICAL SYSTEM INSTALLATION
Vertical Installation Conversion Kit Wiring / Using a Conduit
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 74: Vertical Installation Conversion Kit PCB Connections.
Figure 75: Vertical Installation Conversion Kit Wiring Connection Proce-
dures.
Step 2.
CN_D_PUMP
CN_FLOAT
Terminal (White)
Terminal (Blue)
Connect Terminal
Connect Terminal
for CN_D_PUMP
for CN_FLOAT
Step 3..
Figure 76: Liquidtight 3/4 Inch Elbow
Connector Attached to Flexible Conduit.
55
Advertisement
Table of Contents
