Related Manuals for Avantco Beer Keg Dispenser
Summary of Contents for Avantco Beer Keg Dispenser
- Page 1 User Manual Beer Keg Dispenser User’s Manual 8/2013 Beer Kegs KEGERATRB, KEGERATRS Recommended for household use only. Please read the manual thoroughly prior to equipment set-up, operation and maintenance - 1 -...
-
Page 2: Safety Precautions
DO NOT attempt to operate this unit with a damaged cord or plug. • DO NOT roll the Beer Keg Dispenser with loaded beer kegs on carpeted surfaces. • When transporting the refrigerator, keep the unit in the upright position. Do not tilt the appliance beyond 45°... - Page 3 User Manual Important Safety Precautions for CO2 (Carbon Dioxide) Gas • CO2 gas can be dangerous! CO2 cylinders contain high-pressure compressed gas, which can be hazardous if not handled properly. Make sure you read and understand all the procedures for the CO2 cylinders before installation.
-
Page 4: Parts Diagram
User Manual Parts Diagram Accessories Accessories 1. Keg Coupler 14. Keg Base Board 2. Back Flow Stopper 15. Metal Washer 3. Rubber Washer 16. Caster with Brake 4. CO2 Rubber Directional Washer 17. Caster 5. Beer Tower Washer 18. CO2 Tank Strap 6. -
Page 5: Proper Location
• To ensure that your Beer Keg Dispenser works to the maximum efficiency it was designed for, keep it in a location where there is proper air circulation and electrical outlets. • Choose a location where the Beer Keg Dispenser will be away from heat and will not be exposed to direct sunlight. -
Page 6: Installing The Casters
Follow the steps below to install the casters. 1. Empty the inside of the cabinet completely and lay the Beer Keg Dispenser down on its side. We recommend that you place a piece of cardboard or cloth underneath the cabinet to prevent dents or scratches. -
Page 7: Installing The Beer Tap
User Manual Installing the Beer Tap Follow the steps below to install the beer tap. 1. There are notches on the bottom of the draft arm assembly that line up with grooves inside the opening on the top of the Beer Keg Dispenser. -
Page 8: Installing The Guardrail
4. Wrap the rubber strap that is attached to the interior of Beer Keg Dispenser unit around the CO2 bottle to secure the bottle in place (as shown to the right). - Page 9 Slide the beer keg slowly, ensuring that it is properly located (Fig. 5) and carefully close the door. 6. Your Beer Keg Dispenser comes with a 2.5 lb. CO2 bottle, which should be able to dispense four 15 gallon kegs of beer.
-
Page 10: Cleaning And Maintenance
Operating Your Beer Keg Dispenser Follow the steps below to dispense beer. 1. Make sure that the Beer Keg Dispenser is plugged in properly to a 120V, 60Hz, 15 Amp grounded AC power outlet. 2. Place the drip tray under the beer faucet to avoid messes from excess beer. -
Page 11: Troubleshooting
Beer Keg Dispenser. • Always rinse the beer line if you do not intend to use your Beer Keg Dispenser for a period of time. First, turn off the CO2 and dispense beer until it stops. This will release pressure in the keg so that the coupler can safely be detached. - Page 12 User Manual Cloudy Beer: Dirty glass or faucet. Clean the lines and faucet. See also “Greasy glasses” under flat beer. Beer too cold. Raise the temperature of the keg slightly. Improper pour. Open the faucet quickly and completely. Hold the glass steady at a 45º angle. When it is ⅔...
Need help?
Do you have a question about the Beer Keg Dispenser and is the answer not in the manual?
Questions and answers