Lens Assembly Replacement - Chauvet SlimPAR PRO RGBA User Manual

Lens Assembly Replacement

SlimPAR Pro RGBA User Manual
The SlimPAR™ Pro RGBA has an option available to replace the secondary LED optics, or lens
assembly. This will alter the beam and field angles of the fixture. The wide-angle lens assembly is
installed at the factory. The narrow lens (15°) assembly is available as an optional accessory
(item number SPPRGBALENS15).
To replace the lens assembly in the SlimPAR™ Pro RGBA:
1. Remove the four Allen screws from the front trim ring with a #3 metric Allen wrench.
2. Remove the front cover (with glass still attached to the ring).
3. You now have access to the lens assembly. Use a Philips-head screwdriver to remove
the five screws that hold it in place.
4. Carefully remove the lens assembly. The LEDs and board will now be exposed. Use
caution to prevent damage.
5. Place the new lens assembly in the fixture and reinstall the five Philips screws. Tighten
screws as simultaneously as possible to the same tension. Do not over-tighten the
screws as this could cause damage.
6. Put the front cover in place and reinstall the five Allen screws.
Allen screw
Allen screw
Lens assembly
Front cover
9
Allen screw
Allen screw
Rev. 3