Listening To Messages Using The Base Unit; Listening To Messages Using The Handset - Panasonic KX-TG9541 Operating Instructions Manual

Answering System for Landline
3
MYESN
4
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Playing back the greeting message
Handset / Base unit
1
For line 1: MMENUN#3031
For line 2: MMENUN#3032
2
MbN: Select the desired greeting message. a
MSELECTN
3
Proceed with the operation for your unit.
Handset: To exit, press MOFFN.
Base unit: To exit, press MEXITN.
Listening to messages
using the base unit
When new messages have been recorded:
– M N on the base unit flashes.
– "New message" is displayed.
For line 1: Press M N (PLAY1).
For line 2: Press M N (PLAY2).
R If new messages have been recorded, the base
unit plays back new messages.
R If there are no new messages, the base unit
plays back all messages.
Operating the answering system
during playback
Key Operation
MDN or MCN Adjust the speaker volume
M N
Repeat message
M N Skip message
MPAUSEN Pause message
To resume playback, press M
MnN (STOP) Stop playback
MERASEN Erase currently playing message
*1 If pressed within the first 5 seconds of a
message, the previous message is played.
56
*1
For assistance, please visit http://www.panasonic.com/help
Calling back (Caller ID subscribers
only)
Press MZN during playback.
R To edit the number before calling back, press
MEDITN repeatedly until the phone number is
shown in the desired format (page 48).
R The unit automatically uses the line you set in
line selection mode (page 16) to call back.
When the line selection mode is set to "Auto",
the indicated line (
If the indicated line is already being used or you
want to select the other line, press MLINE 1N or
MLINE 2N.
R To call back using a cellular line, continue from
step 2, "Making cellular calls", page 27.
Erasing all messages for the desired
line
1
MERASEN
2
MbN: Select the desired line. a MSELECTN
3
MbN: "Yes" a MSELECTN
Listening to messages
using the handset
When new messages have been recorded, "New
message" is displayed.
1
To listen to new messages:
For line 1: MPLAY1N
For line 2: MPLAY2N
or
For line 1: MMENUN#3231
For line 2: MMENUN#3232
To listen to all messages:
For line 1: MMENUN#3241
For line 2: MMENUN#3242
2
When finished, press MOFFN.
N.
Note:
R To switch to the receiver, press M
*1 If there are no new messages in the
answering system, MPLAY1N or MPLAY2N is
not displayed.
*2 If there are new messages in both lines,
MPLAYN is displayed.
or ) is used for the call.
*1, *2
*1, *2
N.