Power Management Setup - AOpen i945GTm-VHL Manual

Power Management Setup

The Power Management Setup screen enables you to control the motherboard
green features. See the following screen.
Power Management > ACPI Suspend Type
This function allows you to select suspend types. S1 is Power On Suspend and S3
is Suspend to RAM. Available Options: S1, S3, S1 & S3
Power Management > Soft-off by PWR-BTTN
This is a specification of ACPI and supported by hardware. When Delay 4 sec. is
selected, the soft power switch on the front panel can be used to control power On,
Suspend and Off. If the switch is pressed for less than 4 seconds during power On,
the system will go into Suspend mode. If the switch is pressed for longer than 4
seconds, the system will be turned Off. The default setting is Instant-Off. If
Instant-Off is selected the soft power switch is only used to control On and Off, so
there is no need to press it for 4 seconds, and there is no Suspend.
Available Options: Delay 4 sec., Instant-Off
Power Management > Energy Lake Function
This is a function of Energy Lake Function supports
Available options: Disabled, Enabled
Power Management > Wake On PCI card
This is a function of PCI specification 2.2. PCI bus supports standby current to PCI
card and PCI card can wakeup system if it detects certain activity.
Available options: Disabled, Enabled
Power Management > Power On by Ring
This option lets you specify enable or disable Wake On Modem Ring function.
Available options: Disabled, Enabled
53