Flexible Arm Installation; Remove Monitor Stand For Mounting - NEC MultiSync PA242W User Manual

Flexible Arm Installation

This LCD monitor is designed for use with a fl exible arm.
To prepare the monitor for alternate mounting purposes:
NOTE: For PA302W, the monitor must be installed or moved by two or more people.
• Follow the instructions provided by the manufacturer of the display mount.
• To meet the safety requirements, the monitor must be mounted to an arm that supports the weight of the monitor.
See page 26-27-28 for details. Remove the monitor stand before mounting.

Remove Monitor Stand for Mounting

To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest position.
3. Place monitor face down on a non-abrasive surface (Figure S.1).
4. Place one hand around the base and one hand on the Quick Release Lever.
Push and hold the Quick Release Lever in the direction indicated by the
arrows (Figure S.1).
5. Lift up the stand to unhook it from the monitor (Figure S.1).
The monitor can now be mounted using an alternate method.
Reverse process to reattach stand.
NOTE: Handle with care when removing monitor stand.
Mount Flexible arm
This LCD monitor is designed for use with a fl exible arm.
1. Follow the instructions on how Remove Monitor Stand for Mounting to remove the stand.
2. Using the 4 screws from the stand removal and attach the arm to the monitor (Figure F.1).
100 mm
Weight of LCD assembly: 7.4 kg (PA242W)
Caution: Use ONLY the screws (4 pcs) that are included or M4 sized screws (Length: thickness
of bracket and washer + 10-12 mm) when mounting to avoid damage to the monitor
and stand. To fulfi l the safety requirements the monitor must be mounted to an arm
which guaranties the necessary stability under consideration of the weight of the
monitor. The LCD monitor should only be used with an approved arm (e.g. GS mark).
NOTE: Tighten all screws.
(recommended Fasten Force: 98 - 137N•cm)
100 mm
200 mm 100 mm
Weight of LCD assembly: 8.9 kg (PA272W)
Figure F.1
English-10
Figure S.1
100 mm
10.7 kg (PA302W)
Unit
Mounting
Bracket
Washer
Screw
10-12 mm
Thickness
of bracket
and washer