Table 13: Device Configuration - Status; Table 14: Device Configuration - Settings/Basic Settings - Grandstream Networks GXP21 Series User Manual

Table 13: Device Configuration - Status

MAC Address
IP Address
Product Model
Part Number
Software Version
System Up Time
System Time
Registered
PPPoE Link Up
Table 14: Device Configuration – Settings/Basic Settings
End User
Password
IP Address
802.1x Mode
Grandstream Networks, Inc.
The device ID, in HEXADECIMAL format.
This field shows IP address of GXP
This field contains the product model information.
This field contains the product part number
• Program: This is the main firmware release number, which is always used for
identifying the software (or firmware) system of the phone.
• Boot: Booting code version number
• Core: Core code version number
• Base: Base code version number
• DSP: DSP code version number
• Aux: Aux code version number
This field shows system up time since the last reboot.
This field shows the current time on the phone system.
Indicates whether accounts are registered to the related SIP server(s). GXP can
support four unique SIP profiles.
Indicates whether the PPPoE connection is enabled (connected to a modem).
This contains the password to access the Web Configuration Menu. This field is
case sensitive with a maximum length of 25 characters.
The GXP operates in two modes:
1. DHCP mode: all the field values for the Static IP mode are not used (even
though they are still saved in the Flash memory.) The GXP acquires its IP
address from the first DHCP server it discovers on its LAN. The DHCP
option is reserved for NAT router mode. To use the PPPoE feature, set the
PPPoE account settings. The GXP establishes a PPPoE session if any of
the PPPoE fields is set.
2. Static IP mode: configure all of the following fields: IP address, Subnet
Mask, Default Router IP address, DNS Server 1 (primary), DNS Server 2
(secondary). These fields are set to zero by default.
This option allows the user to enable/disable 802.1x mode on the phone. The
default value is disabled. To enable 802.1x mode, this field should be set to EAP-
MD5.
Once enabled, the user would be required to enter the following information below
to be authenticated on the network:

Identity

MD5 Password
GXP21xx User Manual
Firmware 1.0.1.26
Page 26 of 42
Last Updated: 11/2010