Front Panel Header - Gigabyte GA-H61M-D1 User Manual

5) SATA2 0/1/2/3 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
3
1
6) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, and system status indicator on the chassis to this
header according to the pin assignments below. Note the positive and negative pins before connecting
the cables.
Power LED Power Switch
2
1
Hard Drive Reset
Activity LED Switch
Chassis Intru-
sion Header
short beep will be heard if no problem is detected at system startup. If a problem is detected, the BIOS
may issue beeps in different patterns to indicate the problem.
• HD (Hard Drive Activity LED)
Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is
reading or writing data.
• RES (Reset Switch):
Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if
the computer freezes and fails to perform a normal restart.
• CI (Chassis Intrusion Header):
Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis cover has
been removed. This function requires a chassis with a chassis intrusion switch/sensor.
The front panel design may differ by chassis. A front panel module mainly consists of power
switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your
chassis front panel module to this header, make sure the wire assignments and the pin assign-
ments are matched correctly.
SATA2
2 1
Speaker
• PLED/PWR_LED (Power LED):
System Status
S0
S3/S4/S5
20
19
• PW (Power Switch):
Connects to the power switch on the chassis front panel. You may
configure the way to turn off your system using the power switch
(refer to Chapter 2, "BIOS Setup," "Power Management," for more
Power LED
information).
• SPEAK (Speaker):
Connects to the speaker on the chassis front panel. The system
reports system startup status by issuing a beep code. One single
0
Pin No. Definition
7
1
2
3
4
5
6
7
Connects to the power status indicator
LED
on the chassis front panel. The LED is
On
on when the system is operating. The
Off
LED is off when the system is in S3/S4
sleep state or powered off (S5).
- 13 -
GND
TXP
TXN
GND
RXN
RXP
GND