Computer Setup-Security - HP Compaq Pro 4300 Maintenance And Service Manual

Computer Setup—Security
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 3-3 Computer Setup—Security
Option
Setup Password
Power-On Password
Device Security
USB Security
Slot Security
Network Boot
12 Chapter 3 Computer Setup (F10) Utility
Description
Allows you to set and enable a setup (administrator) password.
NOTE: If the setup password is set, it is required to change Computer Setup options, flash the
ROM, and make changes to certain plug and play settings under Windows.
Allows you to set and enable a power-on password. The power-on password prompt appears
after a power cycle or reboot. If the user does not enter the correct power-on password, the unit
will not boot.
Allows you to set Device Available/Device Hidden for:
●
System Audio
●
Network Controller (some models)
●
SATA0
●
SATA1
Allows you to enable or disable groups of USB ports or individual USB ports. Default is device
available.
●
Front USB Ports
◦
USB Port 0
◦
USB Port 1
◦
USB Port 4
◦
USB Port 5
●
Rear USB Ports
◦
USB Port 8
◦
USB Port 9
◦
USB Port 10
◦
USB Port 11
●
internal USB Ports
◦
USB Port 2
◦
USB Port 3
Allows you to disable or enable the PCI or PCI Express slot. Default is enable.
Enables/disables the computer's ability to boot from an operating system installed on a network
server. (Feature available on NIC models only; the network controller must be either a PCI
Express expansion card or embedded on the system board.) Default is enable.