Maintenance And Cleaning - Electrolux EHG 6760 Instruction Booklet

Maintenance and cleaning

Disconnect the appliance from the electrical
supply, before carrying out any cleaning or
manteinance work.
The hob is best cleaned whilst it is still warm, as spillage
can be removed more easily than if it is left to cool.
Wash the enamelled components with warm soapy
water. Never use abrasive cleaners
Frequently wash the "caps" and the "crowns" with hot
soapy water, carefully taking away any built-up of food.
Carefully wash the stainless steel components with
water, then wipe them dry with a soft cloth.
If the marks are particularly difficult to remove, use
common non-abrasive cleaners or specific products.
Never use steel wool pads or acids.
Cast Iron Pan Supports
The hob has cast iron pan supports.
Take care when removing them. They are fair heavy and
could damage the hob or your kitchen furniture if you let
them fall down.
To keep the pan supports in the correct position, they
are hooked into hinges at the back of the hob. Thanks to
these hooks, you can lift the pan supports for easier
cleaning.
When removing the pan supports, lift them up as shown
in Fig. 2. Never turn the pan supports on the hinges, this
could damage them (Fig. 3).
This keeps the pan supports fixed in place when the
central burner is in use.
Wash the pan supports using hot soapy water. If
necessary, a paste cleaner or a soap impregnated steel
wool pad can be used with caution.
After cleaning, be sure to wipe dry with a soft cloth.
The Burners
The burner caps and crowns (Fig. 1) can be removed for
cleaning. Wash the burner caps and crowns using hot
soapy water, and remove marks with a mild paste
cleaner. A well moistened soap impregnated steel wool
pad can be used with caution, if the marks are
particularly difficult to remove. After cleaning, be sure to
wipe dry with a soft cloth.
Ignition electrode
The electric ignition is obtained through a ceramic
"electrode" and a metal electrode (Fig. 1 - letter C). Keep
these components very clean, to avoid lighting difficulties,
and check that the burner crown holes are not
obstructed.
Periodic Maintenance
Periodically ask your local Service Centre to check the
conditions of the gas supply pipe and the pressure
adjuster, if fitted.
FO 2238
Fig. 2
NO
Fig. 3
YES
5