Dvd Video Operations - Clarion NX509E Owner's Manual & Installation Instructions

Pop M
Rock M
Easy M
Light M
Classics
Other M
Weather
Finance
Children
Social
Religion
Phone in
Travel
Leisure
Jazz
Country
Nation M
Oldies
Folk M
Document
Emergency broadcast
If an emergency broadcast is received, all the
function mode operations are stopped. "Alarm"
appears on the screen and the emergency
broadcast can be heard.
●Canceling an emergency broadcast
1. Touch the [Back] key during receiving the
emergency broadcast. The emergency
broadcast is canceled, and the system returns
to the PTY standby mode.
• You can also cancel the emergency
broadcast by keeping pressing the [SRC]
button for more than 1 second.
❏ Volume setting of TA,
emergency broadcast (Alarm)
and PTY
The volume for TA, Alarm and PTY interrupts can
be set during TA, Alarm or PTY interrupt.
• The factory default setting is "15".
1. Use the [VOL +] and [VOL –] buttons to set
the volume to the desired level (00 to 33)
during a TA, Alarm or PTY interrupt.
• When the TA, Alarm, or PTY interrupt ends,
the volume returns to the level before the
interrupt.
26
Pop Music
Rock Music
Easy Listening Music
Light Classical Music
Serious Classical
Music
Other Music
Weather
Finance
Children's Programs
Social Affairs
Religion
Phone In
Travel
Leisure
Jazz Music
Country Music
National Music
Oldies Music
Folk Music
Documentary

DVD Video Operations

❏ Selecting the DVD Video mode
1. Set a DVD video disc to the DVD player.
The system will automatically read the disc
data, change to the DVD mode (DVD Video
mode), and start playback after a while.
See also "Setting/Ejecting a Disc" (page 17).
WARNING
• Some videos may be recorded at a higher
volume level than desired. Increase the
volume gradually from the minimal
setting after the video has started.
• For your safety, the driver should not
watch the video or operate the controls
while driving. Please note that watching
and operating the video while driving are
prohibited by law in some countries.
Note:
• For your safety, this system has a safety function
which turns off the picture when the car is moving,
so only the audio can be heard. The picture can
only be watched when the car is stopped and the
parking brake is applied.
• If "Audio Only" appears on the screen just after
turning on the ACC power of the car, release the
parking brake while confirming safety, and then
engage the parking brake again.
●When a DVD video disc is already set
1. Press the [SRC] button to display the Source
screen.
2. Touch the [DVD] key to select the DVD Video
mode.
The system changes to the DVD mode (DVD
Video mode), and starts playback from the
previous position.