Powerful Operation; Note For Multi System - Daikin ROOM AIR CONDITIONERS Operation Manual

2SHUDWLRQý0DQXDO
POWERFUL
Operation
POWERFUL operation quickly maximizes the cooling
effect in any operation mode. You can get the maximum
capacity with a touch of a button.
l
Pressing the (POWERFUL) button during operation starts

POWERFUL operation.

l
POWERFUL operation ends in 20 minutes. Then the system
automatically operates again with the settings which were used
before POWERFUL operation.
1
Press
n
To cancel POWERFUL operation:
Press
Notes on POWERFUL operation
l
In COOL and HEAT mode
To maximize the cooling and heating effect, the capacity of
outdoor unit must be increased and the air flow rate be fixed to
the maximum setting.
The temperature and air flow settings are not variable.
l
In DRY mode
The temperature setting is lowered by 3˚C and the air flow rate
is slightly increased.
l
In FAN mode
The air flow rate is fixed to the maximum setting.
êë
.
.
Note for Multi
System
l
Precedence-room setting
When setting the preference-room during installation, the
indoor unit's operation mode always takes priority.
When the precedence-setting room unit is operated in
POWERFUL mode, there are times that air conditioners in other
rooms will temporarily stop in order to centralize power to the
unit in the room.
Please adjust the precedence-room setting to match your life
style. Moreover, for precedence-room settings, please consult
the service shop where you bought the unit.
Precedence-room setting is applied to only 4MX80, 4MK90.
l
COOL/HEAT mode
This mode is used to set the unit to only cool or heat. For
information on using this mode, consult the service shop where
you bought the unit.
COOL/HEAT mode is applied to only 4MX80, 4MK90.
NOTE
<Note for heat pump multi system>
When two or more indoor units have no precedence-room
settings and are set to modes that differ from each other, the
indoor unit which is operated first activates, while the other
indoor unit does not activate and the OPERATION lamp blinks.
(This is not a malfunction.)
An indoor unit that is not in operation will automatically start
and operate in the mode in which a previously operated indoor
unit was stopped. However, if the unit in operation provides
only COOL and DRY modes, simultaneous operation is
possible.
('íéðííì
9
5RRPý$LUý&RQGLWLRQHUVý-ý6HULHV