Setting The Clock; Tips For Saving Energy - Daikin ROOM AIR CONDITIONERS Operation Manual

2SHUDWLRQý0DQXDO
Preparation Before Operation
Indoor unit
n
Setting the air purifying filters
1
Open the front grille .
l
Hold the grille by the tabs on the two sides and lift it until
it stops with a click. (about 60˚)
2
Pull out the air filters.
l
Push upwards the tab at
the center of each air
filter, then pull it down.
3
Set the air purifying filters.
l
Attach an air purifying filter to each air filter.
(See page 14 "Care and cleaning")
4
Set the air filters in their original
positions and close the front grille .
l
Operation without air filters may result in troubles as dust
will accumulate inside the indoor unit.
NOTE

Tips for saving energy

l
Be careful not to cool (heat) the room too much.
Keeping the temperature setting at a moderate level helps
save energy.
Recommended temperature setting
For cooling: 26˚C – 28˚C
For heating: 20˚C – 24˚C
l
Cover windows with a blind or a curtain.
Blocking sunlight and air from outdoors increases the
cooling (heating) effect.
l
Clogged air filters cause inefficient operation and waste
energy. Clean them once in about every two weeks.
êí
n

Setting the clock

1
Press .
AM
2
Press to set the clock to the present
time.
TIMER
PM
l
Holding down ( ) or (
rapidly increases or decreases the time display.
3
Press .
PM
n
Turn the breaker ON
l
Turning ON the breaker opens the flap, then closes it again.
(This is a normal procedure.)
Please note
l
The air conditioner always consumes 15 – 35 watts of electricity
even while it is not operating.
l
If you are not going to use the air conditioner for a long period,
for example in spring or autumn, turn the breaker OFF.
l
Use the air conditioner in the following conditions.
Mode
Operating conditions
Outdoor temperature : 10 to 46˚C
(In 2MX, 3MX, and 4MX : 10 to 43˚C)
Indoor temperature : 18 to 32˚C
COOL
Indoor humidity : 80% max.
Outdoor temperature : –10 to 21˚C
HEAT
Indoor temperature : 10 to 30˚C
Outdoor temperature : 21 to 46˚C
(In 2MX, 3MX, and 4MX : 21 to 43˚C)
DRY
Indoor temperature : 18 to 32˚C
Indoor humidity : 80% max.
l
Operation outside this humidity or temperature range may cause
a safety device to disable the system.
is displayed.
AM
blinks.
) button
blinks.
(Now the clock is set.)
If operation is continued out of this
range:
A safety device may work to stop the
operation.
(In multi system, it may work to stop
the operation of the outdoor unit only.)
Condensation may occur on the indoor
unit and drip.
A safety device may work to stop the
operation.
A safety device may work to stop the
operation.
Condensation may occur on the indoor
unit and drip.
5RRPý$LUý&RQGLWLRQHUVý-ý6HULHV
('íéðííì
7