Preparation Before Operation - Daikin ROOM AIR CONDITIONERS Operation Manual

('íéðííì

Preparation Before Operation

Remote controller
n
Setting the batteries
1
Press with a finger and slide the back
cover to take it off.
2
Set two dry batteries (AAA).
3
Set the back cover as before.
l
This will cause the figures on the display to flash. Set the
clock at this point.
ATTENTION
About batteries
l
When replacing the batteries, use batteries of the same
type, and replace the two old batteries together.
l
When the system is not used for a long time, take the
batteries out.
l
When the operation display screen of the remote controller
is hard to see and the reception become hard, replace the
batteries with new AAA batteries.
l
The attached batteries are provided for the initial use of
the system.
The usable period of the batteries may be short depending
on the manufactured date of the air conditioner.
6
5RRPý$LUý&RQGLWLRQHUVý-ý6HULHV
Position + and
– correctly!
2
3
1
n
Operating the remote controller
l
To use the remote controller, aim the transmitter at the indoor
unit. If there is anything to block signals between the unit and
the remote controller, such as a curtain, the unit will not
operate.
l
Do not drop the remote controller. Do not get it wet.
l
The maximum distance for communication is about 7 m.
n
To fix the remote controller holder
on the wall
1
Choose a place from where the signals reach
the unit.
2
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3
Fit the claw of the holder into the bottom of
the remote controller, and push the remote
controller onto the wall.
Set.
l
To remove, pull it upwards.
ATTENTION
About the remote controller
l
Never expose the remote controller to direct sunlight.
l
Dust on the signal transmitter or receiver will reduce the
sensitivity. Wipe off dust with soft cloth.
l
Signal communication may be disabled if an
electronic-starter-type fluorescent lamp (such as
inverter-type lamps) is in the room. Consult the shop if that
is the case.
l
If the remote control signals happen to operate another
appliance, move that appliance to somewhere else, or
consult the shop.
2SHUDWLRQý0DQXDO
Receiver
Remote
controller
holder
ëä