Setting The Channel Delay Time; Setting Data Skip - Uniden USC230 Owner's Manual

SC230 Paper OM 062206.fm Page 56 Friday, July 21, 2006 7:39 PM
Notes:
• If you select 0, the scanner stays on the system for a
minimal time (only long enough to check current
system activity).
• The default setting is 2 seconds for each system.
• All unlocked channels will be scanned at least once
regardless of this setting.
• The scanner moves to the next system after the hold
time expires, any current transmission ends, and the
channel delay time expires.

Setting the Channel Delay Time

program system
Menu
Select the system
Edit Sys Option
E
Set DELAY Time
This setting controls how many seconds the scanner
waits after a transmission ends before resuming
scanning. Select a value from 1-5 or Off, then press E.
Notes:
• The default setting is 2 seconds for each system.
• This setting applies to all channels within the system.

Setting Data Skip

program system
Menu
Select the system
Edit Sys Option
Set DATA SKIP E
This setting controls how the scanner behaves when it
stops on a channel that has a data signal.
On - the scanner stops briefly on the channel, but then
immediately resumes scanning automatically. Press E to
select.
Off - the scanner remains on the channel until the
transmission stops. Press E to select.
Programming/Editing Optional Settings
E
E
E
E
E
E
56