Setting The Delay Time; Setting The Search Frequency Step; Setting Record - Uniden BCD996T Owner's Manual

Setting the Delay Time

[MENU]
Srch/CloCall Opt
Set Delay Time
This setting determines how long the scanner waits after a transmission ends
before resuming Quick Search or Close Call operation.
1-5 sec — The scanner waits the set amount of time after the transmission ends
before resuming. The default setting is 2 sec.
Off — The scanner resumes immediately when the transmission ends.

Setting the Search Frequency Step

[MENU]
Srch/CloCall Opt
Set Step
This setting lets you select the frequency step used during Quick Search and
Close Call.
Auto — The step is based on the band (see the table at the front of the manual).
This is also the default setting.
5.0 kHz, 6.25kHz,
7.5 kHz,8.33kHz,
10.0 kHz, 12.5 kHz,
15.0 kHz, 20.0 kHz,
25.0 kHz, 50.0 kHz,
100.0 kHz

Setting Record

You can set the REC jack to provide an audio signal to a sound recording device
(tape, PC, flash memory) for live recording of transmissions. This also lets you
record Quick Search and Close Call transmissions.
[MENU]
Srch/CloCall Opt
Set Record
On — enables an output to an audio recorder at the REC (record output) jack.
Off — disables an audio signal at the output jack.
110
F
F
F
F
F
The scanner uses the selected step.
F