Fujitsu MPG3409AT Product Manual page 166

Table 5.19 Ultra DMA data burst timing requirements (2 of 2)
MODE 0 MODE 1
(in ns) (in ns)
NAME
MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX MIN
t 10
AZ
t 20 20
ZAH
t 0 0
ZAD
t 20 70 20
ENV
t 75
RFS
t 160 125
RP
t 20
IORDYZ
t 0 0
ZIORDY
t 20 20
ACK
t 50 50
SS
*1: Except for some instances of t
recipient-to-sender interlocks, i.e., one agent (either sender or recipient) is waiting for the other agent to respond with a signal
before proceeding. t is an unlimited interlock that has no maximum time value. t
UI
minimum. t is a limited time-out that has a defined maximum.
LI
*2: 80-conductor cabling shall be required in order to meet setup (t
*3: Timing for t , t , t and t
DVS DVH CVS
(Data and STROBE) have the same capacitive load value. Due to reflections on the cable, the measurement of these timings is not
valid in a normally functioning system.
*4: For all modes the parameter t
known state when not actively driven.
*5: The parameters t , and t
DS DH
the end of the cable.
Note:
All timing measurement switching points (low to high and high to low) shall be taken at 1.5V.
MODE 2 MODE 3
(in ns) (in ns)
10 10
20 20
0 0
70 20 70 20
70 60
100 100
20 20
0 0
20 20
50 50
that apply to host signals only, the parameters t
MLI
shall be met for lumped capacitive loads of 15 and 40 pf at the connector where all signals
CVH
may be greater than t
ZIORDY ENV
for mode 5 is defined for a recipient at the end of the cable only in a configuration with one device at
C141-E110-03EN
MODE 4
MODE 5
(in ns)
(in ns)
MAX
10 10 10
20 20
0 0
55 20 55 20 50
60 60 50
100 85
20 20 20
0 0
20 20
50 50
t and t
UI, MLI
is a limited time-out that has a defined
MLI
, t ) and hold (t , t ) times in modes greater than 2.
DS CS DH CH
due to the fact that the host has a pull up on IORDY- giving it a
COMMENT
Maximum time allowed for output
drivers to release (from asserted or
negated)
Minimum delay time required for
output
Drivers to assert or negate (from
released)
Envelope time (from DMACK- to
STOP and HDMARDY- during
data in burst initiation and from
DMACK to STOP during data out
burst initiation)
Ready-to-final-STROBE time (no
STROBE edges shall be sent this
long after negation of DMARDY-)
Ready-to-pause time (that
recipient shall wait to pause after
negating DMARDY-)
Maximum time before releasing
IORDY
Minimum time before driving
IORDY (*4)
Setup and hold times for
DMACK- (before assertion or
negation)
Time from STROBE edge to
negation of DMARQ or assertion
of STOP (when sender terminates
a burst)
indicate sender-to-recipient or
LI
5 - 99