Regular Maintenance Procedures - Master Spas LEGEND LSX700 Owner's Manual

Legend series
Hide thumbs Also See for LEGEND LSX700:
Table of Contents

Advertisement

REGULAR MAINTENANCE PROCEDURES

Note: These are areas that will require the spa owner to perform routine maintenance. These are not areas
covered under the warranty of the spa.
CLEANING JETS
The majority of jets in your spa can individually be turned on/off. If any of these jets become hard to
turn, it will be necessary to remove the jet to clean it as grit/sand and mineral deposit may be present.
Jets in the Legend Series and Down East line are removed by turning the collar and then pulling out the
jet.
To Clean Jets
Place the jet(s) in a bucket, fully immerse in white vinegar. Let the jet(s) soak overnight and then rinse
with water. Reinstall the jet(s). It may also be necessary to clean the grit/deposit from the white jet body
using an old toothbrush.
CLEANING DIVERTER VALVES
Some Legend Series and Down East Spas have diverter valves. Due to mineral deposits and grit/sand that
may get into the internal parts of the diverter valve, it may become hard to turn or freeze up completely.
In this case, it is necessary to remove the handle and cap of the diverter valve. Before proceeding, make
sure the power to the spa is turned off.
Turn the cap piece counter clockwise. It may be necessary to put a clean rag over the cap and turn it
with a wrench.
Once loose, the cap and handle can be pulled up out of the white plumbing fitting.
Wipe down the internal piece that attaches to the cap and handle.
Soak the cap and handle in white vinegar.
The white plumbing fitting should also be wiped down. If the surface of the white plumbing has
become too abrasive, you can take wet, fine sandpaper and smooth it out. It is also helpful to use a
lubricant (use silicone based, not petroleum based) to allow for an easier turn of the diverter handle.
Rinse the diverter internals and reassemble.
In the future, it is helpful to turn the diverter valve only when the pump is not on. Cleaning your
diverter valve should occur every time you drain your spa.
DO NOT DIVE.
71

Advertisement

Table of Contents
loading

Table of Contents