Installation Instructions - Master Spas LEGEND LSX700 Owner's Manual

INSTALLATION INSTRUCTIONS

7.
It may be necessary to bleed air from the motor(s) on your spa if, after start up, your spa pumps
do not operate.
Due to the nature of water flow and hydro-therapy pumps, please be advised that air locking of
pumps may occur. Master Spas has taken measures to reduce the possibility of this, but it still may
occur, especially after refilling a spa. This is not a service covered under warranty.
To relieve an airlock situation, loosen the union (see picture) on the discharge of the pump (the end
of the pump that water is being pushed through). Water should leak out. Tighten the union and
test the pump for proper jet flow. If needed repeat process.
8.
Adjust water chemistry according to the instructions provided in the "Spa Water
Maintenance Section".
9.
Your spa water will heat approximately 4 -7 degrees per hour. This varies depending on the size
of the spa. Step into the soothing waters of your Master Spa!
Relax and enjoy.
DO NOT DIVE.
Airlock
Pump Union
Slice Valve
20