Down East (3-4 Pump Systems) Controls - Master Spas LEGEND LSX700 Owner's Manual

DOWN EAST (3 -4 PUMP SYSTEMS) - CONTROLS
Initial Start-up
When your spa is first actuated, it will go into Priming mode, indicated by "Pr." Be sure the pumps and
heating system are free of air by cycling the pumps on and off with the spa-side panel buttons. The spa
will not heat during priming mode, allowing time to verify all air is purged from the heater. The Priming
mode will last for less than 5 minutes (press "Warm" or "Cool" to skip Priming Mode) and then the spa
will begin to heat the spa and maintain the water temperature in the Standard mode.
Portsmouth 3 / Windsor 3 / Exeter 3 / Cape Cod 3
East Hampton SE / Portsmouth SE / Windsor SE / Windsor STS /
Exeter SE / Cape Cod SE (4 Pump System)
Note: Refer to pg. 52 for Somerset operation.
Your system has a 24-hour circ pump. The circ pump and the ozone generator run continuously.
Warm/Cool (80˚F - 104˚F / 26˚C - 40˚C)
The start-up temperature is set at 100F°/37°C. The last measured temperature is constantly displayed on
the LCD.
Note: The last measured spa temperature displayed is current only when the circ pump has been running
for at least 2 minutes.
To display the set temperature, press the "Warm" or "Cool" pad once.
To change the set temperature, press the pad a second time before the LCD stops flashing. Each press
of the "Warm" or "Cool" pad will continue to either raise or lower the set temperature. After three
seconds, the LCD will stop flashing and display the current spa temperature.
DO NOT DIVE. 48