HUSKY LINERS 6650 Care And Use Instructions

THANK YOU FOR SELECTING A HUSKY FLOOR LINER
Your new floor liner is custom molded to fit your particular vehicle. The liner is made to take the place of your
factory floor mats. For correct fit, it is necessary to remove the factory floor mat before installing your new floor
liner. However, do not remove the factory-installed carpeting.
Your liner is made from an engineering resin that is lightweight and extremely tough and durable. The easiest
way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409
®
Armor All , Son-of-a-Gun
INSTALLATION INSTRUCTIONS FOR YOUR NISSAN
XTERRA SECOND SEAT FLOOR LINER
DRIVER'S SIDE
DUE TO DIFFERENCES IN AVAILABLE CONSOLE CONFIGURATIONS, 2000/2001 XTERRA OWNERS MAY
NEED TO TRIM THEIR LINER AS SHOWN ABOVE. THE TRIMMING NECESSARY IS EASILY DONE BY
FOLLOWING THE SCRIBED LINE MOLDED INTO THE PART. A UTILITY KNIFE OR SCISSORS WORK WELL
FOR TRIMMING. PHOTOS OF TRIMMED AND UNTRIMMED PARTS ARE INCLUDED ON BACK.
FROM WINFIELD CONSUMER PRODUCTS
CARE AND USE INSTRUCTIONS
®
or similar items is discouraged as these products make the liner slick.
FRONT OF VEHICLE
LEFT OR
®
or Glass Plus
RIGHT OR
PASSENGER'S SIDE
NOTICE: LEFT MAT
OVERLAPS RIGHT MAT
®
work well. Use of
6650 Front_Back.doc
Rev: 2
12/26/01